Impulse Fault Locator BI-.35S1

1. A 35kv 1mfd. low inductance impulse service capacitor.
2. A VON continuously adjustable impulse control gap.
3. High reliability VON voltage doubler circuit with silicon rectifiers.
4. The fully protected output meter in the high voltage lead indicates true leakagereadings. Ranges 0-10 mic, 0-30 mic, 0-100 mic, 0-300 mic, 0-1 ma, 0-3 ma,0-10 ma.
5. Megohm scales on the output meter allow direct resistance reading from 100,000 ohms to 300,000 megohms.
6. A 0-5 amp A.C. ammeter in input of the 110 (220) volt to 13kv air insulated epoxyimpregnated high voltage transformer.
7. A rugged taut band high torque kilovoltmeter wit ranges of 0-10kv, 0-35kv.
8. A variable autotransformer for continuous voltage adjusment.
9. Power on and off-discharge switch discharges cable through a 2.5 megohm resistor.
10. Two ground relay systems require that the case ground, the 120 volt source ground, and the test lead ground be within 100 ohms or each other in order to operate the unit.
11. Separate sockets for testing and fault locating
12. Varistors are provided between the 120 volt input lines and the case to provide surge protection to the equipment.
13. Shielded test lead, 35 feet (10.6M) long. Other lengths are available such as 60 feet and 75 feet.
14. Optional built in inverter with 15 ft.(4.6m) battery leads permits operation from a 12 volt truck battery

Click Here for Von Training Videos