Hubbell Tension Puller Switching Tool – C400-1907

Tension Puller Switching Tool combines line-tension disconnect switch with Epoxiglas® insulated tool as above. Weathershed polymer skirts are bonded to 1.5″-diameter pole. Compression clamps secure switch hot parts to pole. Bypass stud (.5″-dia.) at each end of switch accepts 3″-wide jumper clamps. Copper switch blade with silver-plated contacts opens to 90˚, or 180˚ with stop pin removed. Galvanized hooks are provided for operation by loadbreak device. With handling rings, this tool may be operated by either hotline tools or rubber-glove techniques. Illustrated instructions give procedures for installation, operation and maintenance. Hot line jumpers installed on conductor and tool’s bypass studs create a parallel circuit. The conductor is securely restrained before cut. Long tail is clamped back onto itself. Portable loadbreak device may be used to open switch. For additional recommendations, refer to ANSI C37.35 IEEE Guide for the Application, Installation, Operation and Maintenance of High Voltage Air Disconnecting and Load Interrupter Switches.

Specifications:

Rating – Volts: 35kV
Rating – Current: 600A
Working Range: 65.00 – 77.00 in
Capacity – Weight: 4000 lb.
Switch: Copper Blade Disconnect
Material: Epoxiglass, Galvanized Steel
Ends: Hotstick Hooks, Non-Swiveling
Tensioning Adjustment: Ratchet Wrench, Hot Stick Lever